User Guide

Thank you very much for purchasing “ACTION BRIDGE”.

“ACTION BRIDGE” is a front fork support device which can be used for both previous model

“MagRoller II” and current model “Action MagRoller”.

As you know, triple roller trainer is the best indoor bicycle trainer to master smooth pedaling with

keeping correct position, but it may be difficult for the beginners to keep his balance on unstable

spinning rollers. Therefore we recommend that he should install “ACTION BRIDGE” to his

trainer. It holds his front fork firmly so that he will be able to train without helpers.

The unique urethane floating mounted front fork support system features quite convenient benefit

that avoiding any damages or troubles on front fork when ride hard.

(Example: Action Bridge with Action Magroller)

ACTION BRIDGE Instruction manual

IMPORTANT NOTES

• ACTION BRIDGE is the helper device for indoor bicycle training only. Don’t use

ACTION BRIDGE for other purposes.

• Read this instruction manual carefully before use. Always keep this manual beside

you.

• There are two different models of ACTION BRIDGE in the width of its frame; “Model-

360” and “Model-450”.

Be sure Model-360 is for normal width (360mm) roller trainer only, and Model-450 is for

wider one (450mm) only.

• Check all bolts are tightened firmly before use. If you are noticed about cracks and/

or any troubles on ACTION BRIDGE, stop using immediately and contact to the dealer

you purchased.

PAGE 1
ACTION BRIDGE Instruction manual (Example: Action Bridge with Action Magroller) Thank you very much for purchasing “ACTION BRIDGE”. “ACTION BRIDGE” is a front fork support device which can be used for both previous model “MagRoller II” and current model “Action MagRoller”. As you know, triple roller trainer is the best indoor bicycle trainer to master smooth pedaling with keeping correct position, but it may be difficult for the beginners to keep his balance on unstable spinning rollers.
PAGE 2
RESOLUTION DIAGRAM HOW TO INSTALL 1 First, cover both Fixing Plates from the outside of roller frame. Insert Knob Bolt through the hole on the roller frame where the front roller can be installed, and then tighten with Sub Fixing Plate temporarilly. 2 Place Frame Reinforcement Plates just on roller frame, and tighten them with Cap Bolts. Frame Reinforcement Plate will disperse the load from the bike to roller frame and control the movement of Frame, so that you should stick them onto roller frame.