User Guide

ManualsBrandsMinoura ManualsOtherBIKE TOWER

- 1 -

! !

BIKE TOWER Instructions Manual

Thank you for purchasing Minoura BIKE TOWER display stand.

Thsi is the display stand which can hold 2 or more bikes (limit 4 bikes) on its cradles at two different

heights and in front and behind the pole.

The main pole is adjustable from 1.6 meter (5’ 3”) to 3.1 meter (10’ 2”) between the floor and the

ceiling of your room.

Most parts are made of light alloy so the completed weight of the Bike Tower is only 3 kgs, therefore

your can move it anywhere you want easily and its simple design can fit everywhere.

IMPORTANT NOTES

• Please read this instructions manual carefully before use.

• Bike Tower is the display stand for ordinary 2-wheel bicycles only. Do NOT use it for any other

purpose, for example, for displaying heaviy electric bikes or tandem bikes.

• Bike Tower is installed between the floor and ceiling using a strong spring and the tension this

provides. Bike Tower MUST be installed firmly on a a solid floor and ceiling using a supporting

beam or load bearing area of the ceiling. Failure to do so may cause damage to your ceiling,

bikes, Bike Tower, and may cause personal injury.

Set the Bike Tower up vertically

from floor to ceiling. Make sure

the Bike Tower is not slanted.

Slanted installation may cause

the Bike Tower to fall down,

causing damage and/or injury.

Set Bike Tower firmly

against a supporting

beam or load bearing

area of the ceiling. Failure

to do so will cause dam-

age to your ceiling.

When setting the main

telescoping pole, make

sure to extend it until the

red warning sign no longer

shows. The warning sign is

located just below the

upper rubber cup.

Red Warning Sign

ceiling supporting beam

Summary of content (4 pages)

PAGE 1
BIKE TOWER Instructions Manual Thank you for purchasing Minoura BIKE TOWER display stand. Thsi is the display stand which can hold 2 or more bikes (limit 4 bikes) on its cradles at two different heights and in front and behind the pole. The main pole is adjustable from 1.6 meter (5’ 3”) to 3.1 meter (10’ 2”) between the floor and the ceiling of your room.
PAGE 2
HOW TO SETUP BIKE TOWER Required tool : 5mm hex wrench (included) We explain the name of each part as below; Upper Rubber Cup Lower Support Height range: 1.6m (5’3”) - 3.1m (10’2”) Angle Adjust Plate (projection is foreside) Upper Pole Pole Joint Alloy Stay Frame Hook Lower Pole Bottom Rubber Cup 1 Loosen the upper bolt on the Pole Joint then extend the main pole. After you fit the main pole to the ceiling, tighten the bolt slightly. (see Fig.
PAGE 3
The distance between the plastic frame hooks can be adjusted to fit different sized bicycles. To do so, loosen the rear nut and adjust the position of the hook. After adjusted to the required position, retighten the nut firmly. (see Fig. D) 4 Now, disassemble the supplied stainless band device by removing the bolt. Wind the stainless band around the pole, and insert the end of the band into the gap between another end and the rectangle nut.
PAGE 4
HOW TO USE BIKE TOWER Bike Tower can stand alone, but we recommend it is set-up next to a wall for increased safety. Lift the bicycle and gently place the top tube into the frame hooks. If the bicycle does not have a standard frame design, it should be supported by the top tube and rear seatstay configuration. (see Fig. I) O X (fig. I) BIKE TOWER USE CHECK LIST You must check the following points before use; 1. Check that there are no cracks in the main pole or plastic brackets. 2.