MINOX NV mini Anleitung Instruction Mode d’emploi
Minox NV mini • Deutsch • English • Français Achtung! Attention! Entfernen Sie bitte niemals bei Tageslicht den Objektivschutzdeckel. Never remove the lens cap in daylight. N’enlevez jamais le couvercle de l’objectif en plein jour.
Contents Introduction Get familiar with your night vision ‘scope - Control elements General information Operating instructions For use in daylight - Inserting the battery - Switching on - Switching off 16 Page Page Page Page Page Page Page Page Page 17 18 18 18 19 19 19 19 19 For use at night - Switching on - Adjustment - Infrared illuminator - Switching off Safe keeping Important information Advice on care Troubleshooting Technical Data Customer Service Conditions of warranty Page Page Page Page Page
Introduction Dear MINOX Customer, Congratulations on your purchase of this night vision ‘scope. You have chosen a product that boasts highest optical quality and precision mechanics. This User’s Manual will advise you on how to obtain the best performance results from your MINOX night vision ‘scope.
MINOX NV mini 4 9 1 2 3 5 6 7 8
Get familiar with your night vision ‘scope Control elements 1. Housing 2. Main power switch 3. Objective lens 4. Eyepiece and focusing ring 5. Infrared illuminator 6. Infrared illuminator power switch 7. Battery compartment 8. Lens cap* 9. Carrying strap position held *never remove in daylight ! 18 General information This top quality optical-electronic product is fitted with a Generation 1+ residual light amplifier.
Operating instructions For use in daylight Inserting the battery Please ensure that the lens of your NightVision scope is covered by the lens cap. Remove the battery compartment lid and insert the battery (1 CR 1/3 N). Always observe correct poling. Fully close the battery compartment again. Switching on To protect the sensitive image tube against irreparable damage, never remove the lens cap in daylight. The small opening in the center of the cap is adequately dimensioned for daylight use.
For use at night Switching on Remove the lens cap. Actuate the main switch and hold it down. The green LED lights up. When you look through the eyepiece you will see a green, fluorescing image. Adjustment Aim at an object situated at a distance of 20 to 30 m (22 to 33 yds). Turn the focusing ring on the eyepiece to get a sharp image. Then turn the front focusing ring to make the image sharper still. Repeat this procedure if necessary.
Important note: For longer battery service life we recommend you not to leave the Night-Vision scope switched on continuously. It is better to switch it off every now and again. Safe keeping Please protect the lens with the lens cover at all times. Important information To avoid irreparable damage to your MINOX night vision ‘scope, please always observe the following instructions: - Never remove the lens cover when using the scope in daylight.
- Always cover the lens with the lens cap when not in use. - Do not expose the device to direct sunlight. - Do not keep the device under extremely low or high temperatures. - Do not keep the device in damp, dusty or dirty areas. - Keep the device safe from any external influence. - Never subject the device to knocks or impact. 22 Advice on care Protect the Night-Vision scope against falling, damp, dirt and extreme temperatures. Protect all optical surfaces against damp and abrasive agents.
Troubleshooting The night vision ‘scope does not switch on Check that the batteries are correctly installed. Check the performance of the batteries. continues the surrounding area may be too bright. This can occur even with mounted lens cap. In a dark environment this phenomena is reduced or disappears completely. No image appears Select your subject matter. Turn the eyepiece adjustment to obtain a sharp image. Then turn the lens ring to further enhance pin-sharp definition.
scope away from the light source immediately. The image will be restored within a period of two minutes. Imaging results can also only be achieved at short distances if there is severe fog, haze or under extremely dark conditions. night vision ‘scope is used correctly the service life is approximately 10,000 hours. The service life is reduced if the night vision ‘scope is exposed to strong light sources such as street lamps or headlights/spotlights.
Technical Data Integral IR LED Optical magnification: Lens diameter Resolution: field of view: Tube type: Diopter compensation: Operating temperatures: Water resistant: Battery: Dimensions Weight Scope of delivery: yes 2x 22 mm / 0.87 inch 35 lp/mm 11° Gen. 1+ +/- 4dpt -30° up to +50° C / -22° up to +122° F yes 1 CR 1/3 N (3.0 V) 33 x 41 x 107 mm / 1.30 x 1.61 x 4.21 inch 180 g / 6.
Customer Service You can reach our Customer Service under the following address, where they will be pleased to help you: MINOX GmbH Walter-Zapp-Str. 4 D-35578 Wetzlar / Germany Tel.: +49 (0) 6441 / 917-0 Fax: +49 (0) 6441 / 917-612 info@minox.com www.minox.
For your notes 27
Conditions of warranty With the purchase of this MINOX product you have acquired a product which has been manufactured and checked to special quality standards. For this product the MINOX GmbH provides warranty of 2 years.
4) When submitting claims under warranty please return the MINOX product together with the typewritten sales slip and a description of the claim to the MINOX GmbH or MINOX agency. 5) Tourists may, if required, make use of the Agency of the country in which they are travelling (within the terms of the Warranty of the MINOX GmbH) by presenting the typewritten sales slip. MINOX GmbH, Walter-Zapp-Str. 4, D-35578 Wetzlar, Germany www.minox.
Änderungen in Konstruktion und Ausführung vorbehalten. Die Marke MINOX ist eine eingetragene Marke der MINOX GmbH, Wetzlar. Design subject to alterations without notice. MINOX is a registered trademark of MINOX GmbH, Wetzlar. Sous réserve de modifications. MINOX est une marque déposée par MINOX GmbH, Wetzlar. MINOX GmbH Walter-Zapp-Str. 4 D - 35578 Wetzlar, Germany Tel.: +49 (0) 6441 / 917-0 Fax: +49 (0) 6441 / 917-612 e-mail: info@minox.com www.minox.
