User Guide

19
Operating instructions
For use in daylight
Inserting the battery
Please ensure that the lens of your Night-
Vision scope is covered by the lens cap.
Remove the battery compartment lid and
insert the battery (1 CR 1/3 N). Always observe
correct poling. Fully close the battery com-
partment again.
Switching on
To protect the sensitive image tube against
irreparable damage, never remove the lens
cap in daylight. The small opening in the
center of the cap is adequately dimensioned
for daylight use.
Actuate the main switch.The green LED display
lights up. When you look through the eye-
piece you will see a bright, green, fluorescing
image.
Switching off
Actuate the main switch. When you look
through the eyepiece you will still see the
green image for a few minutes, before it dis-
appears. This is normal and not a fault, because
the Night-Vision scope always switches off
gradually.