Quick Guide

CONNECTION
You could put the camera
onto the box on the printer's
front side, as shown below.
Power outlet
Plug the power cable into the camera and the power adaptor, then
into a power outlet, plug the USB-Micro-B Cable into the camera and
the 3d printer, as shown in the figure below.
Plug the USB-Micro USB
cable into the camera and
the printer, as shown in the
figure above.
Micro USB
Connect to Printer
Put on Camera
Connecting Cables
*You need to purchase a USB 2.0 Hi-Speed cable if your printer is with Hi-Speed 2.0 slot.
(The camera will take 1-2 minutes when power-up, don't cutoff the power during
this period.)