User Manual

3
USER MAINTENANCE INSTRUCTIONS
All service and repair should be performed by qualified vacuum service representative or electrician.
No user serviceable components are employed in the electrical vacuum lid head assembly. No
lubrication of the motor is required.
CLOTH BAG & HOSE ASSEMBLY
Cloth bag and hose assembly are user maintenance items and can be replaced when worn out.
Cloth bags can be maintained by blowing dust off of the bag and then laundering. Cloth bags should
be completely dried before re-installing into machine. For optimum performance, empty and clean
filter bag regularly. A clogged and dirty bag restricts the flow of air and results in reduced vacuum.
The hose assembly can be maintained by wiping off with a dampened cloth of mild liquid soap and
water, then allowed to dry.
CORD STORAGE
• While not in use storage can be accomplished by winding cord around motor lid assembly. Cord
should be completely unwound from lid assembly during operation.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, return to service center.
• Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or appliance with wet hands.
• Always unplug the machine when removing the motor head off the tank. This equipment should be
stored indoors and not exposed to rain.
A
B
C
D
E
F
829563 Dust Brush Complete
829562 Crevice Tool
1 1/4” (32 mm)
829565 Wand Tube
(2 required)
829849 Hose Assy. 1 1/4 x 8
(32 mm x 2.4 m)
829561 Combination Floor Tool
829564 Upholstery Tool
TOOLS AND ACCESSORIES