Parts and Instruction Manual Bio-Haz Vacuum
This manual is furnished with each new MINUTEMAN Bio-Haz Vacuum. This provides the necessary operating and preventive maintenance instructions. Operators must read and understand this manual before operating or servicing this machine. This machine was designed to give you excellent performance and efficiency. For best results and minimal cost, please follow the general guidelines below: · Operate the machine with reasonable care.
Parts and Instruction Manual
Table of Contents IMPORTANT SAFETY INSTRUCTIONS .............................................................................................. 1 Inspection ............................................................................................................................................ 2 Electrical .............................................................................................................................................. 2 115 Volt ................................................
FOR COMMERCIAL USE ONLY IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING DANGER! - THIS VACUUM IS FOR PICK UP OF PARTICULATE MATERIAL ONLY. NOT FOR VAPOR RECOVERY. WARNING - To reduce the risk of fire, electric shock, or injury: • Do not return to manufacturer for repair. • Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing.
Inspection Carefully unpack and inspect your machine for shipping damage. Each unit is tested and thoroughly inspected before shipment, and any damage is the responsibility of the delivery carrier who should be notified immediately. Electrical - 115 Volt This machine is designed to operate on a standard 15 amp. 115 volt, 60 hz, AC circuit. Voltages below 105 volts AC or above 125 volts AC could cause serious damage to the motor.
WARNING This vacuum may contain potentially hazardous dust depending on its appilcation. Special handling of contaminated disposal bags and filters is recommended. Disposal must be in compliance with local EPA regulations User Maintenance Instructions All service and repair should be performed by qualified vacuum service representative or electrician. No user serviceable components are employed in the electrical vacuum lid head assembly. No lubrication of the motor is required.
Operation and Filter Care Instructions The Minuteman Bio-Haz Vacuum has been specifically designed to clean up hazardous dust of all types. Special filters reduce the incidence of airborne dust that would be created by any other method of cleaning. • During the removal of hazardous dust, do not sweep, scoop, shovel, or in any manner handle other than by vacuuming. • Do not at any time attempt to bypass, remove, substitute or by any other means change the filters used in this vacuum.
(Cont’d) Procedures In Removing Contaminated Filters and Cleaning of Contaminated Tank 6. Slowly pull the top of the plastic bag upwards. When you have the plastic bag fully extended upwards, slowly squeeze the plastic bag closed to avoid trapping excess air. Twist the plastic bag until enough plastic can be tied into a knot. 7. Lift the bag out of the tank and dispose of it properly. 8.
Filter Assembly 9 1) 2) 3) 4) 5) 6) 7) 8) 9) 8 6 Intake Disposable Paper Collector Bag, 384003PKG (10/pkg) Bio Hazard Plastic Bag, 802206PKG (10/pk) Disposable Paper Filter Protector, 761177PKG (10/pkg) Cloth Filter w/Frame Prefilter U.L.P.
Exploded Views Lid Assembly Parts and Instruction Manual Page 7
Lid Assembly BOM ITEM PART NO.
Tank Assembly ITEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 BILL OF MATERIAL - 290010-3 PART NO. REQ’D DESCRIPTION 390087 1 GASKET DIECUT VNN 390110 1 INTAKE ASSEMBLY ALUMINUM 460109 1 TANK 6GAL LOW INTAKE 460114 2 LATCH POLY TNK 460115 1 DOLLY, PLAST VAC TNK BLK 460118 4 CASTER 711160 4 SCR-HI/LO #10 X 5/8 ZINC 712320 2 WSR .22 X .45 X .04 NYL 712638 2 NUT HEX 10-24 SS NYLOC 712824 2 SCR-THUMB 10-24 X .
Cloth Bag Assembly Item 1 2 3 4 5 6 Parts and Instruction Manual Part No. 760244MCH 760406PLT 805040 712764 711909 800056 Qty.
Tools and Accessories Part No. Description 800083 133249 800084 808023 3” Rd Dust Brush Complete Dust Brush HSG 3” Bristle Insert 3” Adapter 800035 12” Crev Tool Complete 290000 290001 290002 Wand Asy 1-1/2”, Complete 800317 10’ 390014 801044 Hose Assy.
Minuteman International Made Simple Commercial Limited Warranty Minuteman International, Inc. warrants to the original purchaser/user that the product is free from defects in workmanship and materials under normal use. Minuteman will, at its option, repair or replace without charge, parts that fail under normal use and service when operated and maintained in accordance with the applicable operation and instruction manuals.