Parts and Instruction Manual Lead Vacuum Dry Only
This manual is furnished with each new MINUTEMAN Lead Vacuum. This provides the necessary operating and preventive maintenance instructions. Operators must read and understand this manual before operating or servicing this machine. This machine was designed to give you excellent performance and efficiency. For best results and minimal cost, please follow the general guidelines below: · Operate the machine with reasonable care.
Table of Contents IMPORTANT SAFETY INSTRUCTIONS .............................................................................................. 1 INSPECTION........................................................................................................................................ 2 ELECTRICAL ....................................................................................................................................... 2 115 Volt ............................................................
FOR COMMERCIAL USE ONLY IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING WARNING - To reduce the risk of fire, electric shock, or injury: • • Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. To avoid electrical shock, do not expose to rain, store indoors. WARNING: To reduce the risk of electrical shock - Do not use on wet surfaces.
INSPECTION Carefully unpack and inspect your machine for shipping damage. Each unit is tested and thoroughly inspected before shipment, and any damage is the responsibility of the delivery carrier who should be notified immediately. ELECTRICAL - 115 Volt This machine is designed to operate on a standard 15 amp. 115 volt, 60 hz, AC circuit. Voltages below 105 volts AC or above 125 volts AC could cause serious damage to the motor.
WARNING This vacuum may contain potentially hazardous dust depending on its application. Special handling of contaminated disposal bags and filters is recommended. Disposal must be in compliance with local EPA regulations USER MAINTENANCE INSTRUCTIONS All service and repair should be performed by qualified vacuum service representative or electrician. No user serviceable components are employed in the electrical vacuum lid head assembly. No lubrication of the motor is required.
Operation and Filter Care Instructions The Minuteman Lead Vacuum has been specifically designed to clean up lead dust. Special filters reduce the incidence of airborne dust that would be created by any other method of cleaning. • During the removal of hazardous dust, do not sweep, scoop, shovel, or in any manner handle other than by vacuuming. • Do not at any time attempt to bypass, remove, substitute or by any other means change the filters used in this vacuum.
(Cont’d) Procedures In Removing Contaminated Filters and Cleaning of Contaminated Tank 6. Slowly pull the top of the plastic bag upwards. When you have the plastic bag fully extended upwards, slowly squeeze the plastic bag closed to avoid trapping excess air. Twist the plastic bag until enough plastic can be tied into a knot. 7. Lift the bag out of the tank and dispose of it properly. 8.
Filter Assembly 8 7 1) 2) 3) 4) 5) 6) 7) 8) 5 6 3 Intake Disposable Paper Collector Bag, 384003PKG (10/pkg) Disposable Paper Filter Protector, 761177PKG (10/pkg) (Optional) Cloth Filter w/Frame PreFilter U.L.P.A. Filter Safety Interlock Exhaust 4 1 2 Changing Of Prefilters In order to prolong the efficiency and performance of the critical filter it is recommended that each pre-filter, debris bag and paper filter protector be changed every time the debris bag is full.
Tools and Accessories Part No. Description 829563 Dust Brush Complete B 829562 Crevice Tool 1 1/4” (32 mm) C 829565MCH Telescoping Wand Tube A D 829849 390013 762241 829566 Hose Asy 1 1/4” x 8’ (32 mm x 2.
Exploded Views Lid Assembly Parts and Instruction Manual Page 8
Lid Assembly BOM Item Part No. 1 2 3 4 5 6 6A 7 7A 8 9 9A 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 *** *** 110029 110030PKG 290017 290031 290032 380001-4 380054 380005 380028 380064 381020 740083 390062 460001 460101 460104MCH 460120 700287 710307 711124 711125 711160 711161 711162 711301 711502 711551 711553 715009 740014 740029 740938 809754 828893 831801 831801-1 832201 833237 829117 829220 Qty.
Tank Assembly Item 1 2 3 4 5 6 7 8 9 10 11 12 *** Part No. 390087 390110 460109 460114 460115 460118 711160 712320 712638 712824 750118 828893 290010 Parts and Instruction Manual Qty. 1 1 1 2 1 4 4 2 2 2 1 4 1 Description Gasket Diecut VNN Intake Assembly Aluminum Tank 6 Gal Low Intake Latch Poly Tank Dolly, Plast Vac Tnk Blk Caster SCR Hi/Lo #10 x 5/8 Zinc WSR .22 x .45 x .048 NYL Nut Hex 10-24 SS Nyloc SCR-MC 10-24 x .
Bag Assembly Item 1 2 3 4 5 *** Part No. 711909 712764 760244MCH 760406PLT 805040 800056 Parts and Instruction Manual Qty. 4 4 1 1 1 1 Description Rivet Pop .19x.
Minuteman International Made Simple Commercial Limited Warranty Minuteman International, Inc. warrants to the original purchaser/user that the product is free from defects in workmanship and materials under normal use. Minuteman will, at its option, repair or replace without charge, parts that fail under normal use and service when operated and maintained in accordance with the applicable operation and instruction manuals.
