Instruction manual

Parts and Instruction Manual
Page 10
Brush Load / Unload
To load the brush, first center
the E17/E20 brush deck over
the scrub brush.
Lower the scrub deck by
releasing the deck lift pedal.
With the key turned on, pull the
bail handle to spin the scrub
brush onto the scrubdeck.
Loading Brush
Unloading Brush
To unload the brush, first lift the
scrub deck by pressing down
on the deck lift pedal . Make
sure the pedal is in the “home”
position shown below.
If done correctly the brush
should release from the scrub
deck and fall to the floor.
Momentarily (1 to 2 seconds)
turn the key to the “Brush
Unload” position.
Note: The brush will release
only when the key returns to the
off position (O).