User Manual

RACKMOUNT CONFIGURATION

This UPS comes with mounting brackets for the standard 19" (46.5cm) rack

installed on the UPS. The mounting brackets to fit a 23" (59.2cm) rack and

Rail Kits for 4-post racks and cabinets are also available. The screws for

mounting the UPS to the rack are included.

CONNECTING THE BATTERIES

(QUALIFIED SERVICE PERSONNEL ONLY)

Please read all of the WARNINGS and CAUTIONS before attempting to con-

nect the batteries.

1. Remove the front panel retaining screws.

2. Lay the front panel on top of the UPS.

3. Verify proper polarity. Connect the battery connectors (red and black)

together.

NOTE: Some sparking may occur this is normal.

4. Re-install the front panel onto the UPS.

5. Re-install the front panel retaining screws.

6. Connecting the Batteries is complete. See Connecting your Equipment.

NOTE: If you are using an External Battery Pack with this UPS series,

the UPS must be configured so that the UPS will report the correct

estimated runtime on the LCD screen and in the Power Monitoring soft-

ware and/or the SNMP card. See the Power Monitoring software or the

SNMP card’s User's Manual to configure the UPS.

CAUTION! DO NOT USE THE MOUNTING BRACKETS TO

LIFT THE UPS. The mounting brackets are ONLY for securing the

UPS to the rack.

NOTE: The mounting brackets can be mounted in the middle of the UPS.

1. Remove the UPS from the shipping box.

2. Mount the UPS into the rack and secure with the retaining screws. WARN-

ING: Use two or more people when installing the UPS. Use CAUTION, the

UPS is extremely heavy. Do not move the rack after the units have been in-

stalled. The rack may become unstable due to the weight distribution.

3. The Rackmount Configuration is complete. See Connecting the Batteries.