User Manual

9
8
INSTALLATION PLACEMENT
This ED-XFR series is ONLY intended to be installed in an indoor temperature
controlled environment that is free of conductive contaminants. DO NOT oper-
ate the unit in: extremely dusty and/or unclean areas, locations near heating
devices, water or excessive humidity, or where the unit is exposed to direct
sunlight. Select a location, which will provide good air circulation for the unit at
all times. Route power cords so they cannot be walked on or damaged. The
AC inputs of these Step Down Transformers are ONLY intended to be con-
nected to the output of their respective UPS models. This ED-XFR series is
not intended for use in a computer room as defined in the Standard for the
Protection of Electronic Computer/Data Processing Equipment ANSI/NFPA
75.
Operating Temperature (Maximum): 0 to 40°C (+32 to +104°F)
Operating Elevation: 0 to 2,000m (0 to +6,562 ft)
Operating and Storage Relative Humidity: 95%, non-condensing
Storage Temperature: -15 to +50°C (+5 to +122°F)
Storage Elevation: 0 to 15,000m (0 to +49,213 ft)
INSTALLATION
Be sure to read the installation placement and all the cautions before installing
the ED-XFR. Place the unit in the final desired location and complete the rest
of the installation procedure. See the “Rackmount Configuration” to install the
unit into the rack. USE CAUTION: The ED-XFR, UPS and Battery Pack are
extremely heavy. Use the appropriate number of personnel when installing the
UPS system.
CAUTION! DO NOT USE THE MOUNTING BRACKETS TO LIFT THE STEP
DOWN TRANSFORMER. The mounting brackets are ONLY for securing the
unit to the rack.
Chapter 3: Installation
RACKMOUNT CONFIGURATION
Use the included rackmount brackets and screws to mount the ED-XFR in a
rack by following the steps below.
USE CAUTION: The ED-XFR is extremely heavy. Use the appropriate number
of personnel when installing the UPS system.
CAUTION! DO NOT USE THE MOUNTING BRACKETS TO LIFT THE
STEP DOWN TRANSFORMER. The mounting brackets are ONLY for se-
curing the unit to the rack.
1. Attach the rackmount brackets to the mounting holes on the side panel of
the ED-XFR as shown below.
2. Follow steps 1 through 4 to install the ED-XFR into the Rail kit. See the
figure below.
Step 1: Adjust the length of the rail according to the rack.
Step 2: Securely tighten the wing nuts.
Step 3: Secure the rail to the rack with the enclosed screws.
Step 4: Slide the ED-XFR onto the rail and secure to the rack with the
enclosed screws.
NOTE: The ED-XFR, UPS and Battery Pack are extremely heavy. Use the
following placement when rack mounting:
1. The ED-XFR should be installed close to the bottom of the rack.
2. Then install the Battery Pack right above the ED-XFR.
3. Then install the UPS right above the Battery Pack.