Specifications

Empty Dirt hopper

Traction Drive

The traction drive system uses a friction wheel (1) and a V-belt (2) driving the wheel axle.

When actuating the traction drive control lever, the friction wheel arm (3) with its friction wheel

(1) is pressed against the drive shaft (7), thus allowing power transmission. Note: dust

extractor fan and side broom will rotate as soon as motor is running. Keep hands and fingers

away from any moving parts to avoid injury.

Replace Broom Roller

The broom roller bears 10 rows of bristles and consists of 4 halves. A new broom is 9.8" dia.

(250mm). The broom roller should be replaced when reaching a dia. of 9" (230 approx. mm) to

function properly.

To remove the broom roller:

• Tilt the Kleen Sweep 35W back on the handlebar, as shown. Remove 4 ea. cylinder

Hexagon screws, rotate roller through 180, and remove cylinder Hexagon screws from

1 Dirt hopper control lever 2 Latch

3 Bar for dirt hopper wheels 4 Dirt hopper

• Depress lever (1) to the right to unlock

• Hold dirt hopper by its handle (3) and

pull to the rear, empty hopper

• Slide dirt hopper into opening, exert

pressure against latch (2) until click is

audible, to ensure the dirt hopper is

installed in place.

1. Friction wheel

2. V-belt

3. Friction wheel arm

4. Cocking roller for broom roller drive

5. V-belt for broom roller drive

6. Control cable for friction wheel arm

7. Drive shaft for traction drive, broom roller

and side broom drive assy’s.