Specifications

the other half. Pull drive pin out of broom shaft. For installation, reverse the above

sequence of operations.

Adjust Sweeping Track

In case of broom roller wear and after replacing the roller broom, adjust sweeping pattern as

follows:

• Start the machine and rotate broom roller for a short period of time (static)

• Lift front end of machine and pull back.

• If adjusted properly, a parallel line of sweep is visible on the ground (sweeping track).

This sweeping track width is adjusted to approx. 2" (50 mm) by rotating the hand wheel

CW or CCW. Sealing strips (1 to 4) have to be inspected for wear in regular intervals

and replaced as required. Sealing strips slightly should touch the ground.

Replacing the Side Broom

• Tilt the Kleen Sweep 35W back on its handlebar (also refer to previous section, "replace

broom roller")

• Remove attaching bolt (1) underneath side broom

• Pull-off side broom

• Plug-on new side broom and secure; torque attaching bolt light tight only, to avoid

damage to the broom hub.

1. Sealing Strip, Forward

2. Sealing Strip, Right Hand

3. Sealing Strip, Rear

4. Sealing Strip, Left Hand

5. Broom Roller