Service manual

10. Testing the Throttle Potentiometer
8. If they do not find a problem here, have them retest at the connector at the Trio
con
t
ro
ll
er.
9. Reconnect the plug at the throttle potentiometer.
10. Unplug the P3 connector (The large white connector) on the controller under the seat on the riders
and behind the two rear panels on the ES2832s and CP2832s.
11 L t th bl k/ d th bl k/ i k i
11
.
L
oca
t
e
th
e
bl
ac
k/
orange an
d
th
e
bl
ac
k/
p
i
n
k
w
i
re.
12. Measuring across the black/orange and black/pink wires the resistance should be zero ohms in the
neutral position. It should 5k in the full throttle position.
13. Measure across the black/pink and the black/white wires. The resistance should be 5K (5
thou t ition When th pedal is at full throttle the re istance should drop to
thousand)
in
the
neutral
position
.
When
the
pedal
is
at
full
throttle
the
resistance
should
drop
to
zero.
14. If your reading is different with this test check all the connections between the controller and the
throttle control, including the seat switch.
Note: when moving the throttle to the
full position the resistance ould be smooth without
Note:
when
moving
the
throttle
to
the
full
position
,
the
resistance
should
be
smooth
,
without
dropping out for both tests. If the resistance does not go to 5K during the test, the arm and
the potentiometer may need to be adjusted to achieve it.
Page 37