Specifications

Parts and Instruction Manual

Page 8

fter double scrubbing, the operator should use the vacuum only mode to recover

the dirty solution water from the floor.

When the machine is running in this mode, the machine will only lower the rear

squeegee and turn on the vacuum system to recover the dirty solution from the floor.

This mode is usually chosen after double scrubbing to recover the dirty solution but it

can also be used to pick up spills. When the operator sets the directional switch to

forward, the rear squeegee will be lowered to the floor as the vacuum turns on,

pulling the dirty solution water from the rear squeegee into the recovery tank. If the

operator stops moving forward and sets the directional switch to reverse, the rear

squeegee will retract (protecting it from damage) and the vacuum motor will turn off

after a few seconds. If the operator quits moving in either direction, the machine will

automatically raise the squeegee and turn off the vacuum motor after a few seconds.

When the machine is set in this mode, none of the cleaning functions of the machine

will operate. This mode is only used to transport the machine from one location to

another at a faster rate of speed.

This control will adjust the amount of solution that is being dispersed to the floor

while in one of the scrub modes. Adjust the control clockwise to increase the

amount of solution being dispersed. The amount of solution applied is variable to a

maximum of 1 GPM.

This gauge displays the level of charge remaining in the machine’s batteries. The

gauge consists of 10 LEDs. (3 Green, 4 Amber, 3 Red) If the battery life is low, the

battery gauge bar icon will be flashing to inform the operator that the machine is

almost out of power. Once this signal is displayed, all functions will shut off, including

transport mode. The operator must then turn the key switch OFF and then ON to

reset the machine. The machine will then have only a few minutes left of reserve

power to briefly use Vacuum Only mode to pick up any remaining solution on the

floor and Transport mode to return to the charging station. This gauge will also

display a fault code if the system has an error. This code is represented by a specific

number of flashing LEDs. See Fault/Diagnostic Codes for specific code information.

Vacuum Only Mode

Transport Mode

Solution Control Knob

Battery Gauge