Specifications

Parts and Instruction Manual
Page 16
When installing a cylindrical deck to a machine:
1. Install brushes after the deck has been mounted to avoid flat spots on the brushes.
2. Use a piece of cardboard underneath the deck to prevent scratches to the painted
surface when sliding the deck under the machine.
3. Make sure the scrub deck is oriented correctly with the spray jets towards the front
of the machine.
h
en installing a disc scrub deck to a machine:
1. Install brushes on the scrub deck; this aids the installer in sliding the deck assembly
into position.
2. Make sure the scrub deck is oriented correctly with the solution hose tee fitting
towards the front of the machine.
1. Park the machine on a flat or level
surface.
2. Turn the key switch to the ON
position and select the transport mode
with mode selector knob.
3. Slide the scrub deck assembly
underneath the machine (follow
instructions as described above)
4. Position the scrub deck to align the
mounting brackets with the mounting
lugs on the lift linkage.
5. Lower the lift linkage to the floor by
pressing the manual override switch for
five seconds. (see figure)
6. Lower the lift linkage mounting lugs
until they barely touch the scrub deck
mounting brackets.
Manual Override Switch, located
behind electrical panel.
7. Fasten with the four (4) 711242 bolts, 711515 flat washer and 711546 lock washer.
8. For cylindrical scrub deck only:
a. Remove the Yellow 3 sided
knob on the side squeegee
assembly and swing out the side
squeegee to reveal the access
door.
b. Remove the two access doors
(one on each end) by removing
the three wing nuts on each door.
c. Install the brushes by sliding
them through the access
opening. (see figure for correct
orientation.)
Scrub Deck Installation
Installation Instructions