Specifications

Parts and Instruction Manual
Page 24
1. To stop scrubbing, select the Transport mode. This will automatically stop the
Solution Flow, raise the Scrub deck, and raise the Rear squeegee (there is a 15
second delay for the vacuum motor).
2. Drive the SCV to a designated dirty water disposal area and empty the Recovery
tank. To empty, remove the Drain hose from its storage hanger. Unscrew the plug
and hold the hose end above the water level in the tank to avoid sudden,
uncontrolled flow of dirty water. With the plug completely off, carefully direct the
water flow to the desired drain. Reinsert the plu
g
and ti
g
hten and return to its stora
g
e
hanger.
3. The recovery tank should be rinsed out to remove solids in the tank. Open the
Cleanout cap to remove the Stopper plug. Tilt the recovery tank (similar to
accessing the batteries) and clean the sludge that has settled in the sump area by
either back flushing or by scraping it out. Be sure to tightly secure the Stopper plug
and cleanout cap before continuing to operate the scrubber.
4. Refill the solution tank and continue scrubbing until the job is done or when the
machine runs out of power.
5. The battery gauge LEDs will flash to signal the operator that the machine is almost
out of power. Once this signal is displayed to the operator, all functions will shut off
(brush will turn off and the scrub deck will raise up, water flow will cease, the rear
squeegee will raise up and the vacuum motor will turn off) including the transport
mode. The operator has to turn the key switch OFF and then, ON to reset the
machine.
The machine will then have only a few minutes left of reserve power to
briefly use Vacuum Only mode to pick up any remaining solution on the floor and
Transport mode to return to the charging station.
:
1. When finished scrubbing, select the Transport mode, all functions will shut off
(brush will turn off and the scrub deck will raise up, water flow will cease, the rear
squeegee will raise up and the vacuum motor will turn off). Drive the machine to a
service area for daily maintenance and review items that may need service.
2. Empty the solution tank, by directly opening the Garden hose valve underneath the
machine into a drain on the floor or use a garden hose and attach it to the fitting to
remotely drain the solution tank. Rinse the tank with clean water to prevent any
build-up of dried up chemicals that could cause clogging in the plumbing.
3. Empty the recovery tank as described on line 15 and 16.
4. Remove the brushes or pad holders and rinse them in warm water and hang to dry.
5. Remove the rear squeegee, rinse with warm water and reinstall after cleaning.
6. Remove the side squeegees, rinse with warm water and remove the debris box
(cylindrical system only) and clean thoroughly. The debris box can be removed from
either side of the machine by tilting the box up and away from the housing and then
pulling it out. Reinstall the debris box and side squeegees after cleaning.
7. Check the maintenance schedule on the next page and perform any required
maintenance before storing the machine.
8. Store the machine indoors in a clean dry place. Keep from freezing. Leave solution
and recovery tank lids open for ventilation to prevent odor build-up.
9. Turn Key switch OFF (O) and remove key.
After Use