Instructions / Assembly

Directions

WARNING! Removal of old paint by sanding, scraping or other means may

generate dust or fumes that contain lead. Exposure to lead dust or fumes may

cause brain damage or other adverse health effects, especially in children or

pregnant women. Controlling exposure to lead or other hazardous substances

requires the use of proper protective equipment such as a properly fitted

respirator (NIOSH approved) and proper containment and cleanup. For more

information, call the National Lead Information Center at 1-800-424-LEAD (in

US) or contact your local health authority.

1. Surface must be dry and free of wax, grease, polish, old finishes in poor

condition or any foreign matter.

2. Sand to a smooth, uniform surface. DO NOT USE STEEL

WOOL. Remove dust with a cloth dampened with water or mineral

spirits. Let dry completely.

3. If desired, apply Minwax® Wood Finish™ or Minwax® Water Based

Wood Stain to unfinished interior wood surfaces following label

directions. Wait at least 24 hours before applying Polycrylic® over

Minwax® Wood Finish™.

4. Stir well before and regularly during use. DO NOT SHAKE. FINISH

APPEARS MILKY IN CAN BUT DRIES CRYSTAL CLEAR.

PAGE 1
Directions WARNING! Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup.
PAGE 2
5. Apply a thin coat of Polycrylic® with a high-quality synthetic bristle brush. Apply in one direction with the grain. Do not overbrush. 6. Let dry at least 2 hours then sand with very fine sandpaper (220 grit) to ensure an even finish and proper adhesion of additional coats. Do not use steel wool. Remove all dust. 7. Apply second coat. For additional coats, repeat Step 6 before applying. Three coats are recommended. 8. After final coat, allow 3 hours before light handling and 24 hours before normal use.
PAGE 3
WARNING! VAPOR HARMFUL. IRRITATES EYES, SKIN AND RESPIRATORY TRACT CAUTIONS: CONTAINS ALKYL PROPANOLS, ETHYLENE GLYCOL ,GLYCOL ETHERS AND 1-METHYL-2-PYRROLIDINONE. CONTAINS MATERIAL THAT MAY CAUSE ADVERSE REPRODUCTIVE EFFECTS AND MAY ADVERSELY AFFECT THE DEVELOPING FETUS BASED ON ANIMAL DATA. VAPOR HARMFUL. Use only with adequate ventilation. To avoid overexposure, open windows and doors or use other means to ensure fresh air entry during application and drying.