Instructions / Assembly

8. Apply at least three coats on exterior surfaces. For interior surfaces, apply at
least three coats on unfinished wood and two coats on surfaces already
finished.
9. 18. After final coat, allow 24 hours before normal use.
Note: Above dry times are based on good ventilation temperature of 77°F and 50%
relative humidity. Lower temperature, higher humidity, lack of air movement or
application of thick coats will extend drying times. Helmsman® Spar Urethane is not
recommended for large exterior surfaces where maintenance would be difficult, such
as decks and siding. Slight ambering may be experienced when Helmsman® Spar
Urethane is applied over light-colored stains or wood surfaces. Always spot test an
inconspicuous area to ensure satisfactory results.
NOZZLE CARE
1. After each use, clear valve by holding can upside down and spraying until only
clear gas comes out.
2. If spray button becomes clogged, wear eye protection, wipe off button opening
with lacquer thinner- Do NOT stick pin in spray button opening.
DANGER: Rags, steel wool, other waste soaked with this product,
and sanding residue may spontaneously catch fire if improperly
discarded. Immediately place rags, steel wool, other waste soaked
with this product, and sanding residue in a sealed, water-filled
metal container. Dispose of in accordance with local fire regulations.