Operation Manual

14
Turning on and off
For normal operation, turn off your Mio by sliding the power switch to the OFF position. Your Mio enters a
suspended state. To use it again, slide the power switch to the ON position. Your Mio will be back to where you
left off.
Moov 100/200-Series Moov 300/500-Series
Shutdown and hardware reset
Occasionally, you may need to perform a hardware reset when your Mio stops responding; or appears to be
“frozen” or “locked-up.”
You can perform a hardware reset by shutting down your Mio and then turning it back on. To shut down your
Mio, slide the power switch to the RESET position. To turn on your Mio after shutting it down, slide the power
switch to the ON position.
How do I monitor the battery status?
Your Mio has an internal battery that when fully charged, should provide power for up to 3 hours.
The battery indicator light on the top of the Mio indicates the level of internal battery charge:
 Green - battery full
 Orange - battery charging
You can monitor battery power status on the Power screen.
Note: The battery may not be fully charged when you use your Mio for the first time.
To access the Power screen, tap and hold on the map screens.
How do I charge the battery?
The Battery Status bar displays External Power while the battery is charging; when the battery is fully charged,
the Battery Status bar will display at 100%.
 To charge your Mio in a vehicle, plug the in-vehicle charger into on the bottom of your Mio and the other
end into the vehicle power socket.