ADD-ON DEVICE Quickstart Guide Alarm Keypad Model No. KYP1300 What's inside: 1x Alarm Keypad 2x Double-Sided Tapes Mounting Accessories Broadband internet connection, iOS or Android phone and home router required.
English Get to Know Your Device 1 2 3 5 9 6 7 4 8 1 . Green LED Normal On : Power on 2. Blue LED Flashes Once : Arm / Stay or Disarm 10 11 12 13 14 3. Red LED Flashes Once : Wrong programming Flashes Once Every 3 Seconds : Low battery indication, please replace the batteries. 4. Wake Up Key 5. Arm 6. Arm in Stay Mode 7. Disarm 8. SOS Key 9. Battery Slot 10. Wired Cables Interface 11 . Tamper Switch The tamper switch will be activated if case is opened 12. Screw Hole 13. Rear Cover 14.
1 . Unpack your device and accessories. 2. Pair the device with the Security Shuttle within 1-10 feet to make sure the connection is working well. 3. Pull and remove the plastic strip to initiate battery contact. 1-10 ft 1-10 ft Step 2: Add a device 1 . Open the app, tap on the menu button " " and select "Device Management". 2. Press the add button " + " next to Sensor List. 3. Follow the app instructions to scan the QR code located on the device.
English Step 3: Mount your device Before you mount your device, see if it's within Security Shuttle’s range. 1 . Take your device to the room you want to use it in. 2. Press " " then " SOS " for 3 seconds, if you receive an notification saying " Emergency ", you are within range. Installation 1 Open the keypad case, fix the rear cover at the suitable mouting location. 2 Fasten the front cover on the rear cover.
English 3 Screw the bottom on. Operation Press " " to activate keypad then enter admin password # or user password # before operating. + admin password / user password + # • Admin password is 123456 as default • User password is 1234 as default Note: If there is no operations within 5 seconds after pressing " will exit setup state automatically.
English Function Press Button Mute Press button, then press within 1 second to enter Siren Delay - "No Siren - Exclude Emergency Events" mode. Press button, then press cancel Siren Delay mode. Unmute within 1 second to Press SOS for 3 seconds to activate an immidate alarm. SOS Emergency Call Note: It is recommended to enable function of "Emergency Call with Password" to avoid false operation. See Settings. Settings Press " " then enter admin password # 9 to enter setting state.
Press Button Mark Quick Arm On 1 Once enabled, users can press " + " to arm the system without password. Quick Arm Off 1 Touch Tone On 2 Touch Tone Off 2 Emergency Call with Password 4 Emergency Call without Password 4 Change Admin Password new password # 6 digits Change User Password new password # 4 digits # (0-99s) Arm Delay 0-99s # # Once enabled, the green LED will flash when a button is pressed.
Troubleshooting Tips Are your devices listed in your app? If you’re having trouble installing your devices, see if they’re listed in your app: • Navigate to > Device Management to see if all your devices are listed. • Tap + next to the device category and follow the on-screen instructions to add any missing devices. Are your devices communicating with Security Shuttle? • If your devices don’t connect to Security Shuttle, they might be too far away.
