User's Manual

ManualsBrandsMipro Electronics ManualsAudio EquipmentWireless Microphone

LCDDISPLAY

WIRELESSMICROPHONESYSTEM

ElectronicsCo.,Ltd.

Headoffice:814,Pei-KangRoad,Chiayi,600,Taiwan.

Taipeioffice:5,Lane118,Sung-tehRoad,Taipei,110,Taiwan.

Web-http://www.mipro.com.twE-mail:mipro@mipro.com.tw

InstructionManual

Summary of content (5 pages)

PAGE 1
LCD DISPLAY WIRELESS MICROPHONE SYSTEM Instruction Manual Electronics Co., Ltd. Headoffice:814,Pei-KangRoad,Chiayi,600,Taiwan. Taipeioffice:5, Lane118,Sung-tehRoad,Taipei,110, Taiwan. Web-http://www.mipro.com.tw E-mail:mipro@mipro.com.
PAGE 2
HANDHELD WIRELESS MICROPHONE NOTE﹕ 1. PARTS NAME AND FUNCTIONS GROUP 1 2 3 CHANNEL B A T 4 GROUP CHANNEL B A T 5 6 7 (Fig.1) 1. Grille: Protects cartridge, prevents "POP" noise and prevents microphonefrom rolling withpolygonal shape. 2. Color Ring: For frequency differentiation. 3. Housing: Upper portion to be connectedtocapsule module and battery. Internally, it holds transmitter PCB. 4. Functions of LCD Display 5. Battery Compartment: Designed to accommodatetwo 1.5V(AA) batteries. 6.
PAGE 3
HANDHELD WIRELESS MICROPHONE 3. FUNCTIONS OF LCD DISPLAY HANDHELD WIRELESS MICROPHONE 4. Battery Status: GROUP CHANNEL BAT ERR 1. ERR Message: When "ERR" appears, it means "Error with the system" Please refer to the following codes to diagnose which error you are experiencing. ERR no01→EEPROM is not being programmed or internal data error. ERR no02→Testing only. ERR no03→The frequency you are about to program into the system exceeds microphone's upper limit.
PAGE 4
EQUIPMENT DESCRIPTION SPECIFICATIONS FOR ACT-707H TRANSMITTER 1. Frequency Range 2. Frequency Generation 3. Switching bandwidth 4. Channel Grid 5. Frequency Stable 6. Modulation 7. RF Output Power (50 ohms load) 8. Spurious Emission 9. Nominal Deviation 10. Audio Frequency Range 11. Distortion (at 1KHz and nominal DEV) 12. Preemphasis 13. Battery 14. Current Consumption 15. Operation Voltage 16. Antenna 17. Dimension In mm 18. Wight 19.
PAGE 5
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.