User's Manual

Personal Wireless Public Address SystemPersonal Wireless Public Address System
14
15
TRANSMITTER MICROPHONE BATTERY CHARGING PROCEDURES:
NOTE:
!
!
!
!
!
Lay the PA system on a flat surface.
Press the switch on the compartment door to “OPEN” position. The compartment door
will now swing down on its hinge.
Insert the bottom (metal contact points) of the transmitter microphone into the bottom
slot. Charging begins immediately denote by the flashing LEDs on Wireless Mic Battery
Meter .
The transmitter microphone will charge regardless which side was inserted.
Gently close the battery compartment door. Ascertain the compartment door is firmly
shut by pushing in gently and a click sound is heard.
!
!
Charging begins automatically during storage regardless if MA-202 is turned on or off.
Once the transmitter microphone is fully charged, the built-in charging circuitry will
automatically cut-off and stop the charging. No additional power will be consumed or
used.
TROUBLESHOOTING-PORTABLE PUBLIC ADDRESS
Adjust volume
Turn power switch on
Reduce volume
Turn power switch on
No Sound or Faint Sound
From Speaker
Power Indicator Not On
Distorted Sound From
Speaker
Weak, Distorted Sound.
Power Indicator Flickers
Excessive Hum or Noise
Shortened Battery Life
Battery CHARGE Indicator
Not Flickering when
plugged into AC Outlet
Excessive Feedback
POSSIBLE CAUSEPROBLEM SOLUTION
Power switch is turned off
Rechargeable Battery is
discharged
Excessive wind noise or
breath “pops”
Rechargeable Battery is
“dead”
Batteries level is low
Microphone too close or
directly in front of the
speaker
sound source (requiring
the volume to be turned
up to compensate)
Input signal too strong
Volume set too high
Microphone too far from
Input Cable not shielded
Old or overused battery
Rechargeable Battery is
“dead”
Battery is not charged
for over 3~4 months
Battery is not charged
for over 3~4 months
Battery is fully charged
(CHARGE indicator is lit)
Plug into AC outlet to
recharge
Use windscreen on
wireless & wired
microphones.
Replace battery and plug
into AC outlet to recharge
Plug into AC outlet to
recharge
Move microphone away
from the speaker
microphone or move
microphone closer to
sound source
Adjust input signals
Reduce volume
Speak closer to the
Use shielded cable
Recharge or replace
battery
Replace battery
Recharge or replace
battery
Recharge or replace
battery
N/A
Volume turned down
Power switch is turned off
Volume set too high
11