User guide

RECEIVER VFD INTERFACE
Displays all Parameters
Working Frequency
4
Transmitter Battery Meter
8
10
Audio Signal Meter
2
Interference Indicator (lit denotes presence of interference)
6
Preset Channels (can be programmed)
1
RF Signal Meter
5
Squelch Meter (levels can be programmed)
9
Group (can be programmed)
Diversity A/B Antenna
3
Working Channel
7
AF
A
B
1 2
3
4
5
6 7 8
SQ
MHz
GRP
BAT
ACT
MENU
Display Panel and Buttons
10
11
Diversity Receivers Diversity Receivers
5
43
2
87
9
6
AF
A
1 2
3
4
5
7 8
SQ
MHz
GRP
BAT
6
1
10
Receiver Parameters
3 parameters can be selected and programmed by the button.
See instructions below:
MENU button: To set receiver parameter values
MENU
GROUP setting
GRP
AF
A
1 2
3
4
5
6 7 8
SQ
MHz
GRP
BAT
Blinking GRP cursor
ACT
MENU
Press once to increase
by one group
Press once to decrease
by one group
Press Once
Instructions:
1. Press and release the button once. The ----GRP---- cursor starts blinking to
denote it is ready to accept parameter changes.
2. During blinking, press or button to one of the 6 groups.
3. Press and release the button once to confirm the change. The ----GRP----
cursor stops blinking and the new group is now stored into memory.
To exit GRP mode:
1. GRP mode deactivates automatically if or button is not pressed within 5
seconds. The VFD panel dims automatically, too.
MENU
MENU