Owner's manual

SQUELCH Setting

Press Down Up

Instructions:

1. Press and release the ‘SET' button until cursor starts to blink denoting it is

ready to accept parameter changes.

2. During blinking, press and release ▼ or ▲ button to decrease or increase the

squelch level.

3. Press the 'SET' button to confirm the change.

WARNINGS:

Decreased SQ level setting has higher sensitivity level resulting in longer, maximize

reception range.

Increased SQ level setting has lower sensitivity level resulting in shorter, limited

reception range.

SET

Instructions:

NOTE:

(1) 961 frequencies can be user-defined and up to 8 frequencies can be

stored in Group 11.

1. Press and release the 'SET' button until both icon and group number start to

blink.

2. During blinking, press and release ▼ or ▲ button to group 11.

3. Press the 'SET' button until it stops at FRQ cursor.

4. Press 'SET' button again until the first 3 digit of frequency starts to blink denoting

FRQ it is ready to accept parameter changes.

5. During blinking, press ▼ or ▲ button to decrease or increase parameter value by

1MHz.

6. Press the 'SET' button to confirm the change. Once change is saved, the last 3 digits

of the frequency starts to blink.

7. During blinking, press ▼ or ▲ button to decrease or increase parameter value by

25KHz.

8. Press the 'SET' button to confirm the change.

9. Up to 8 different frequencies can saved and stored into Group 11- - 01 to 08.

Caution:

The 8 saved frequencies in group 11 may not be compatible and interference-free and

therefore, not recommended to be used simultaneously at the same venue.

User-Defined FREQUENCY Setting

Press

SET

Diversity Wireless SystemsDiversity Wireless Systems