User Guide ACT-71HC / ACT-72HC Rechargeable Handheld Transmitter All rights reserved. Do not copy or forward without prior approvals MIPRO. Specifications and design subject to change without notice.
WARNING 1. FOR OUTDOOR USE: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. 2. UNDER WET LOCATION: Apparatus should not be exposed to dripping or splashing and no objects filled with liquids, such as vases should be placed on the apparatus. 3. SERVICE INSTRUCTIONS: CAUTION - These servicing instructions are for use by qualified service personnel only.
Rechargeable Handheld Transmitter Rechargeable Handheld Transmitter Contents Handheld Controls and Indicators 1 Handheld Controls and Indicators 3 Operating Instructions for Insertion & Removing Battery 5 Patented Protection Cover 7 LCD Display Screen 2 8 How to Setup Transmitter Parameters 3 13 Battery Status 15 Setting MUTE 16 General Tips for Improving System Performance 1 4 7 8 12 13 0 1 FREQUENCY 6 718.
Rechargeable Handheld Transmitter Rechargeable Handheld Transmitter Operating instructions for insertion & removing battery 1 Capsule Module: Protects detachable microphone capsule module and internal foam prevents breathing, wind and POP noises. 2 Fixed Ring 3 Battery Compartment: Accommodates one 18500 rechargeable battery. 4 Housing: Protects transmitter PCB, battery compartment and batteries. 5 LCD Panel: Displays transmitter parameters.
Rechargeable Handheld Transmitter ! Rotate and remove microphone grill counter clock direction. ! Press both sides of Fixed Ring to pull out Fixed Ring. ! Insert or remove battery accordingly. Insert battery according to its correct polarity for a proper fit. Wrong polarity will not fit properly. ! Power on the transmitter to check if battery is fresh and inserted correctly. LCD lit denotes battery inserted correctly.
Rechargeable Handheld Transmitter ! When power is off, reverse-installation of protection cover will turn on the switch automatically. To turn off the system, remove the cover to turn off. ! Protection cover must be attached during operation for full protection. ! Rechargeable Handheld Transmitter LCD Display Screen A1 A2 GRP CH 01 01 AF MUTE Color-coded channel identification clip can be attached to the bottom of protection cover.
Rechargeable Handheld Transmitter Rechargeable Handheld Transmitter How to Setup Transmitter Parameters ! Remove protection cover to expose MODE button and SET button. ! MODE Button ! Group & Channel and Frequency are factory pre-set, thus, its parameter values are displayed after it is ACT synced. Values cannot be changed. Press “MODE” button to access one of the functions below. SET Button ! Press SET button and LCD wills start flashing. During flashing, press SET button to change parameters.
Rechargeable Handheld Transmitter Setting Input Gain Level Setting RF Output Power ! Selectable AF GAIN between 12dB to -6dB with 3dB step parameter up or down selection. ! Press MODE button until AF GAIN mode appears. ! Press SET button once to activate function. ! Press SET button to select the desired sensitivity level. ! Press MODE button to confirm and save the change. ! The higher the sensitivity level, the lower the dynamic range of input signals.
Rechargeable Handheld Transmitter MUTE MODE Rechargeable Handheld Transmitter Battery Status ! MUTE MODE: Select from MANUAL and DISABLE. ! Press MODE button until MUTE MODE appears. Press SET button once, the LCD screen starts flashing to denote it is ready to accept mode changes. Press SET button to change between MANUAL and DISABLE in cycle. Press MODE button to confirm and save the change, or LCD will stop flashing after 5 seconds and parameter will be saved.
Rechargeable Handheld Transmitter ERR Message ! Rechargeable Handheld Transmitter Setting MUTE When “ERR” appears in the display it indicates that an operational error has occurred. Please refer to the following codes to diagnose which error you are experiencing. ERR no01 EEPROM is not being programmed or internal data error. ! Press MUTE button to enter MUTE mode. ! Under MUTE mode, press MUTE button to exit MUTE mode. ! MUTE button is operable when MUTE MODE is set in MANUAL mode.
Rechargeable Handheld Transmitter General Tips for Improving System Performance 1. Performer should avoid holding the microphone over or near the antenna section as this will deteriorate transmission efficiency. Severe deterioration if performer directly covers up the antenna section with both hands. 2. Many performers tend to hold the microphone by the top grille. Unfortunately, this position seriously degrades both the sound quality and directionality of a microphone.