Manual

Setting MUTE
! Press MUTE button to enter MUTE mode.
! Under MUTE mode, press MUTE button to exit
MUTE mode.
! MUTE button is operable when MUTE MODE is
set in MANUAL mode.
MUTE
AF MUTE
AF INPUT
14
15
A B
C
AF MUTE AF MUTE
718.275MHz
FREQUENCY
0 dB
AF GAIN
D
RF-LOW
RF POWER
AF MUTE
E
AF MUTE
MANUAL
MUTE MODE
AF MUTE
01 01
GRP CH
ERR Message
! When “ERR” appears in the display it indicates
that an operational error has occurred. Please
refer to the following codes to diagnose which
error you are experiencing.
ERR no01 EEPROM is not being programmed or
internal data error.
ERR no02 For testing only.
ERR no03 The frequency you want to program is
above the switching bandwidth of the
transmitter. Use a receiver with an
appropriate frequency group. (At this time
the microphone is still operating and the
frequency remains unchanged. To clear the
displayed "ERR" message, switch the
handheld transmitter off and on again.)
ERR no04 The frequency you want to program is
below the switching bandwidth of the
transmitter. Use a receiver with an
appropriate frequency group. (At this time
the microphone is still operating and the
frequency remains unchanged. To clear the
displayed “ERR” message, switch the
handheld transmitter off and on again.)
! “Group” & “Channel” : When both the group
and channel numbers are displayed, it means
that you are using the pre-programmed
frequency of the receiver.
! “Channel” Only : If “Channel” only is displayed
, it means that you are using a frequency which
is not pre-programmed.
Rechargeable Handheld TransmitterRechargeable Handheld Transmitter