User Manual
SpirolabIII – User’s Manual Code MIR 980067 REV 0 Page 35 / 47
Generates the Flow/Volume curves of the last test.
'
The data stored in the memory are those of the best tests. The current test can be printed by pressing . To print a
test saved on file after recalling it press . To interrupt printing press .
The printout report includes a header line with the date, time, the BTPS value at the time of the test, patient details, the
FILE No., any pre-set ethnic correction factor and the predicted value set used.
There follow the Flow/Volume and Volume/time curves, which relate to either the last or best test performed.
Press from the main screen to print the best test results.
To print the last test press while viewing the last test.
Lastly, the measured parameters and spirometry test interpretation are shown.
In the case of a PRE test, the following are shown:
Predicted calculated predicted values
PRE measured value before drug administration
%Predicted values percentage value against predicted values
In the case of a POST test then the graph will show the two curves superimposed and in addition to the above-
mentioned parameters, the following values:
POST measured value after drug administration
%CHG % variation (+/-) between POST and PRE.
From the measured parameter’s screen (
or key, or recalled from memory) the subject’s name, date and
time of test is shown on the bottom of the screen.
3 DATA TRANSMISSION
SpirolabIII includes a “Bluetooth” wireless data transmission system. This connection is via radio and allows the
transferring of all the data in memory for two different operations:
• transfer to a cell phone, which then transmits the data to a PC by modem;
• transfer to a Bluetooth-enabled printer, for printing.
The following paragraphs contain in-depth information on these two procedures.
3.1 DATA TRANSMISSION VIA BLUETOOTH TO A CELL PHONE
SpirolabIII can be connected to a cell phone with this system installed. The transmission of data with this technology
allows the transfer of all data in memory of the SpirolabIII.
The sequence of operations to follow is described below.
3.1.1 Preliminary operations
? # '
9 " : ( 9
= 2 E E : DD= 2 EE
3.1.2 Setting the Phone Number
• With SpirolabIII switched on, press .
• Use vertical scroll key to select “Bluetooth Set-up” then press .
• Use vertical scroll key to select “Phone Set-up” then press .
• Enter the number with the numerical keyboard, and again press ; the Configuration Menu will appear.