User Manual

SpirolabIII – User’s Manual Code MIR 980067 REV 0 Page 36 / 47
• Use to return to the main screen.
3.1.3 Data Transmission through Bluetooth
• From the main screen press
• Use vertical scroll keys to select Bluetooth settings and press
• select “intended use” and press
• it is described the transmission way and ,if correct, it is required to confirm it with “OK” to activate the connection to
the device choosen as default in the configuration menu.
• when the request is from mobile phone, type the code shown on the screen (relative to the device’s Serial Number
reported on the back label of SpirolabIII)
• are executed all the next connection steps.
• When the connection is active, data are transmitted from the selected modem
At the end of the transfer data process the following message “Connection Completed” is shown.
The screen will show the following information:
• The device used for the connection;
• The pre-set phone number.
• The preset PIN (corresponding to the serial number of the machine).
To interrupt data transmission during the Bluetooth connection press to end the connection and to return to the
main screen.
Where no device has been setup for data transmission, a message will appear on the display to start searching for
enabled devices. After setting the device the connection will start up automatically.
3.1.4 Data Transmission via Bluetooth for printing


 


=     ? D
! 3 ? %? 
The Bluetooth system enables SpirolabIII to transfer test data directly to a printer with Bluetooth. The sequence of
activities to be followed is:
• When the test is finished press twice
• SpirolabIII will carry out the phases of connection.
• At the end of the transmission SpirolabIII will show the message “CONNECTION COMPLETED”, returning
automatically to the main screen
Previous tests stored on file can also be printed. Use the procedure described in Paragraph 2.11 to print required tests.
• When the required test is shown on the display, press twice
To interrupt data transmission during Bluetooth connection press to end the connection and to return to the main
screen.
Where no printer has been set up, a message will appear to search for devices. After the device has been set up it will
automatically be enabled for printing.
When searching for Bluetooth enabled devices, SpirolabIII will check the address of that device and where a previously
registered device has changed name, it will be automatically updated.
3.2 CONNECTION TO A PC
SpirolabIII can be connected to a PC and perform tests online. Two connection types are used: USB port or RS 232
port.
3.2.1 Connection to a PC through a USB port


 


?  SpirolabIII =( ! 3 ? ' = '  ' 
