User Manual

spirobank G User Manual cod. 980026 Rev 2.0 Page 35 of 46
3 DATA TRANSMISSION
WARNING
Read the instructions carefully before starting data transmission, taking care to
ensure that all the information has been properly understood.
3.1 Data Transmission via Bluetooth for printing
WARNING
Printing is possible only if the printer has a Bluetooth connection; alternatively an
USB adaptor can be installed on the printer in order to enable a Bluetooth
connection.
The printer used must be in the list of printers accepted by the device. To have a
copy of the updated list please contact the manufacturer or send an email to the
following address: [e-mail]
The Bluetooth system enables spirobank G to transfer test data directly to a Bluetooth
enabled printer. Proceed as follows:
• From the main screen select the test to be printed with
.
• On the next screen press
( icon)
• Press
( icon)
• Choose one of the tests of the relevant patient using
, or .
Tests stored in memory can also be printed. Use the search method as described in
Paragraph 2.6 to select and print out relevant tests.
• On the test screen press
and then .
• spirobank G will carry out the connection.
• At the end of transmission spirobank G will show “CONNECTION COMPLETED”, and
return automatically to the main screen.
To interrupt the Bluetooth connection during transmission press ESC to return to the main
screen.
Where no printer has been set up, a message will appear to search for devices. After the
device has been set up it will automatically be enabled for printing data.
3.2 Connection to a PC through USB port or via Bluetooth
WARNING
Before connecting spirobank G via USB or Bluetooth to a PC, winspiroPro must be
installed to interface with the device.
It is important prior to initiating the following procedure to know the version of the
operating system installed on the PC used for the connection (from control panel
click on “System”, where the operating system installed on the PC can be checked).