User guide

6
Caution! Ensure supply pipework is
fl ushed before installing the shower
valve.
4. Assemble the shower valve with a
sealing washer in each inlet and
attach to the offset connectors.
5. Tighten the nuts using a suitable
spanner.
6. Connect the shower fi ttings to the
shower valve outlet.
7. Turn on the water supplies and check
for leaks at all pipe connections.
Stud Partition, Laminated Panel, or Unfi xed Rear-entry Pipework Installation
1. Screw the mounting bracket onto the
offset connectors.
2. The mounting bracket must extend in
the same direction as the offset of the
offset connector. The angle between
the offset connector and the mounting
bracket must be less than 45°.
Otherwise, the mounting bracket will
not fi t under the concealing plate.
3. The mounting bracket boss should
protrude to the rear, facing the wall.
Sealing Washer
Shower Valve
Shower Valve Outlet
Wall Mounting Bracket
Offset Connector
Mounting Bracket
Offset Connector
Offset Connector
Wall
Mounting Bracket
Boss
45
°
45°