User guide

Cover Retaining Screw

Cover

Service Tunnel

Make sure that the electrical supply

is turned off at the mains and that the

water supply is fully turned off.

Remove the three screws, the cover

and the service tunnel.

Inlet Filter - Cleaning/Renewing

Read the section “Important Safety Information” rst

Hold a wrench across the ats of the

metal connector. Unscrew the lter

using another wrench as shown. Clean

or renew the Filter as necessary. Ret

in reverse order making sure the Filter

is screwed fully home.

Do not overtighten! Make sure

plumbing connections are sealed

before restoring electricity supply.

Refit the cover making sure it is

correctly located. Do not overtighten

the screws.

Filter

SERVICING

WARNING

There are no user serviceable parts inside the shower.

Servicing of the shower must only be carried out by qualied, competent

personnel following the instructions provided in this guide and those provided

with any spare part.

Before replacing any parts, ensure that the underlying cause of the malfunction

has been resolved.