User guide

19
Using your Shower
Read the section “Important Safety Information” rst.
Note! At the end of every shower make sure that the shower head points into the
catchment area. A small amount of water may be retained in the shower handset
after the shower has been turned off. This may drain over a few minutes.
Press the ‘Start/Stop’ button, light
on the button comes on.
2.
Switch on electrical supply.
1.
Set to desired position.
3.
Residual water may drain over a
few minutes.
7.
4.
_
+
Check water temperature before
entering shower.
5.
_
+
Allow 10 - 15 seconds for any temperature adjustments to reach the
handset.
6.
Press STOP button, light on the
button goes out. Shower ow will
continue for a few seconds before
stopping. Isolate power.