User guide

21
COMMISSIONING
1. General Commissioning
Hose Washer
Hose
Flow Control
Knob
Temperature
Control Knob
1.1. Make sure the ow control knob is
turned to the "stop" position and
the electrical supply is isolated. If
applicable remove the appropriate
circuit fuse.
Caution! Do not over-tighten the
hose connector.
1.2. Connect the exible hose from the
shower fitting to the outlet of the
appliance. Ensure the hose washer
is tted.
1.3. Turn the water supplies fully on at the
isolating valves. Check that water is
not leaking from the bottom of the
case.
1.4. Switch on the electrical supply to the
product.
1.5. Tu r n t h e f l o w c o n t r o l k n o b
anticlockwise fully to start the shower.
Check that water ows freely from the
shower within a few seconds.
1.6. Turn the flow control knob fully
anticlockwise to select the maximum
ow.
1.7. Tu r n t h e t e m p e r a t u r e k n o b
anticlockwise to check the hot supply
and clockwise to check the cold
supply.
1.8. Turn the ow control knob clockwise
to the "stop" position to switch off the
shower and stop the ow of water.