User guide

5.1. Remove the front cover, refer to

section: 'Maintenance, 3. Front

Cover – Removal'.

5.2. Disconnect the electrical supply cable

from the terminal block.

5.3. Remove the exible hose from the

appliance.

5.4. Re move the t hree wall fixing

screws.

5.5. Using the push-t release tool, push

back and hold the collets from the

supply pipework, lift the Mira Event

XS from the wall to remove the supply

pipework from the inlet manifold.

5.6. Remove the screws securing the inlet

manifold and mixer assembly using

a T10 Torx screwdriver. Unclip the

pump transfer tube.

5.7. Remove the inlet manifold and mixer

assembly.

5.8. The ports adjacent to the mixer

assembly contain the inlet check

valves. The check valves can be

removed and replaced if required.

Ensure the check valve is inserted

with the ‘O’ seal on the check valve

facing into the outlet port of the

manifold.

Mixer

Assembly

Inlet

Manifold

Remove Securing

Screws

Transfer

Tube

5. Inlet Manifold, Check Valve - Removal and Installation

The following procedure can be applied to cleaning or renewing the inlet manifold,

inlet check valves or ‘O’ seals.

Warning! Before proceeding turn off the electrical and water supplies. The electricity

supply must be turned off at the mains and, if applicable, the appropriate circuit fuse

removed. Mains electrical connections are exposed when the cover is removed.