User guide

IMPORTANT SAFETY INFORMATION

1. Warning!

1.1. Products manufactured by us are safe and without risk provided they are

installed, used and maintained in good working order in accordance with our

instructions and recommendations.

1.2. THIS APPLIANCE MUST BE EARTHED. ENSURE SUPPLEMENTARY

BONDING COMPLIES WITH THE "REQUIREMENTS FOR ELECTRICAL

INSTALLATIONS".

In accordance with the current edition of ‘The Plugs and Sockets etc. (Safety)

Regulations' in force at the time of installation, the Mira Event XS is intended to

be permanently connected to the xed electrical wiring of the mains system.

1.3. DO NOT connect the Mira Event XS to a mains-fed water supply. Such a

connection will damage the Mira Event XS, and is not covered under the

manufacturer’s guarantee.

1.4. The Mira Event XS must not be tted where it may be exposed to freezing

conditions. Make sure that any pipework that could become frozen is properly

insulated.

1.5. DO NOT operate the Mira Event XS if it is frozen. Allow the Mira Event XS to

thaw before using again.

1.6. DO NOT operate the Mira Event XS if water leaks from the unit, maintenance

will be required before the Mira Event XS can be safely used.

1.7. DO NOT allow the Mira Event XS to be run dry.

1.8. DO NOT t any form of outlet ow control. Only Mira recommended outlet

ttings should be used.

1.9. There are no user serviceable components beneath the cover of the Mira

Event XS. Only a competent tradesperson should remove the cover.

1.10. If any of the following conditions occur, isolate the electricity and water supplies

and refer to “To contact us”, on the back page of this guide.

1.10.1. If the cover is not correctly tted and water has entered the case.

1.10.2. If the case is damaged.

1.10.3. If the Mira Event XS begins to make an odd noise, smell or smoke.

1.10.4. If the Mira Event XS shows signs of a distinct change in performance,

indicating a need for maintenance.

1.10.5. If the Mira Event XS is frozen.

1.11. Turn off the electrical and water supplies before removing the cover. The

electricity must be turned off at the mains and, if applicable, the appropriate

circuit fuse removed.

1.12. Mains connections are exposed when the cover is removed.

1.13. Moving parts are exposed when the cover is removed.

1.14. Ensure all electrical connections are tight, to prevent overheating.