User guide

13
Mira Logic Built-in Variable Shower Fittings (biv)
Read the section: Installation Requirements before proceeding with the installation.
The slide bar should be positioned to one side of the shower control at a convenient
height for all the family. It should be positioned so that the handset discharges down
the centre line of the bath, or across the opening of the shower cubicle. The handset
should be directed away from the shower control.
Solid and Dry-lined Wall Installation
1. The 15 mm copper pipework from the
outlet of the shower control must be
vertical or horizontal, and not at an
angle, so that it does not interfere with
the installation screws.
2. The 15 mm copper pipework must
protrude through the finished wall
surface by 21–23 mm.
Note! If it is necessary to trim the pipe
to length, remove any burrs before
proceeding.
3. Loosely screw the backplate to the
wallplate, using the two backplate
screws provided.
4. Place the backplate/wallplate
assembly over the copper pipe with the
arrow pointing up. The screw holes
should be at 40° to the horizontal.
5. Mark the positions of the two wallplate
fixing holes.
Arrow
Wallplate Fixing
Holes
Backplate
Wallplate
Backplate
Screws
21–23 mm
15 mm Copper Pipe
Shower Control
15 mm Copper Pipe