User guide

14
6. Remove the backplate/wallplate
assembly from the wall.
7. Separate the backplate and the
wallplate.
8. Drill the two 6 mm wallplate holes.
9. If necessary, make a recess 6 mm
deep to accept the wallplate.
10. Fit the two wall plugs supplied.
11. Fit the wallplate to the wall with the
two wallplate screws supplied.
12. Temporarily fit the two backplate
screws into the wallplate. This will
prevent the fixing holes from becoming
blocked with plaster or grout.
13. Finish the surface of the wall as
required.
14. Remove the two backplate screws
from the wall.
15. Place the backplate over the copper
pipe with the arrow facing up and
tighten the two backplate screws.
Make sure that the foam seal abuts
the finished wall surface.
16. Check that the ‘O’ seal is fitted inside
the backplate nut. Fit the olive and the
backplate nut over the copper pipe and
tighten the nut.
17. Check that the second ‘O’ seal is fitted
to the outside of the backplate nut.
Press the elbow onto the backplate,
make sure that the clips on the elbow
engage with the backplate.
18. Press the shroud over the elbow, make
sure that it engages with the lugs on
the backplate.
19. Fit the slide bar, handset and soap dish
refer to section: Mira Logic Exposed
Variable Shower Fittings (ev).
6 mm
Backplate
Screws
Fixing Holes
Backplate
Backplate
Screws
Copper Pipe
Arrow
Olive
Backplate Nut
‘O’ Seal (Inside)
Elbow
Clips
‘O’ Seal (Outside)
Shroud