User guide

19
16. Ensure that the ‘O’ seal is fitted on the
backplate nut. Push the BIR assembly
over the backplate nut onto the
backplate.
17. Fix the BIR assembly to the backplate
using the four cover screws provided.
Note! If necessary, a 9 l/min flow
regulator can be fitted in the BIR
assembly with an adaptor – contact
Customer Services.
18. Fix the upper shroud to the BIR
assembly using the four self-tapping
screws provided.
19. Snap the lower shroud into position.
21. Install the soap dish, refer to section:
Soap Dish Installation.
‘O’ Seal
BIR Assembly
Backplate
Cover
Screws
Upper Shroud
Self-tapping Screws
Lower Shroud