User guide

20
Shower Cubicle, Laminated Panel, or Stud Partition Wall Installation
25 mm
5.5 mm
5.5 mm
48 mm
Mounting Plate
Backplate
Backplate Screws
Panel
22–25 mm
15 mm Copper Pipe
Wallplate
Panel
Finished
Wall
Surface
Shower Control
15 mm Copper Pipe
1. The 15 mm copper pipework from the
outlet of the shower control must be
vertical so that it does not interfere with
the installation screws.
2. Cut a 25 mm hole in the panel.
3. Cut two 5.5 mm holes at 48 mm
centres in the panel.
4. Place the mounting plate behind the
panel, and feed the copper pipe through
the mounting plate and the panel. Make
sure that the pipe protrudes 22–25 mm
from the wall.
Note! If it is necessary to trim the pipe
to length, remove any burrs before
proceeding.
5. Holding the mounting plate in position
behind the panel, fix the backplate to
the mounting plate, through the panel,
with the two backplate screws.
6. Complete the installation following
steps 15 to 21 of the Mira Logic bir –
Built-in Rigid Shower Fittings: Solid
and Dry-lined Wall Installation
section.