User guide

7
General
Make sure that the shower ttings are installed by a competent installer.
Installations must comply with Water Regulations (Bye-Laws, Scotland), and any
Local Regulations and Building Regulations in force at the time of installation.
Before installation carefully inspect the new xture for any signs of damage.
The slide rail should be positioned to one side of the shower control at a
convenient height for all the family. The slide rail can be xed to a at wall or into
a corner.
Note! To prevent back siphonage and water supply contamination, the handset
must either be prevented from dropping below the spill over level of the bath or
shower or have an additional single check valve in the system. Single check
valves may already be installed as part of the shower control
Install the Shower Fittings Complete
Wall Mounting
1. Decide on a suitable position for
the slide rail avoiding buried cables
and pipes. Make sure that when the
hose retaining ring is placed on the
lowest position on the slide rail there
is a minimum of 25 mm between the
handset and bath/tray spill-over level.
This is necessary to prevent
back-siphonage.
Note! Special consideration should
be given to fixing arrangements
when installing onto a dry lined, stud
partition, shower cubicle or laminated
panel wall structures. Installers may
wish to obtain alternative proprietary
cavity xing, or choose other options,
however, these methods of xing are
beyond the scope of this guide.
Minimum 25mm
INSTALLATION