User guide

9
6. Hold the slide rail assembly against
the wall in the desired position.
Note! If fixing the slide rail into a
corner see "Corner Mounting"
page 13.
7. Use the slide rail supports as a
template and mark the positions of
the top and bottom xing holes.
Note! When marking the position of
the holes, if using the vertical oval
hole on the top of the slide rail, then
use the horizontal oval hole on the
bottom xing. This will allow you to
make slight vertical and horizontal
adjustments to the slide rail.
8. Check that the slide rail is vertical
before drilling xing holes.
Caution! Make sure that you avoid
buried pipes and cables when you drill
the wall.
9. Drill two 8.0 mm xing holes, one at
the top of the slide rail and one at the
bottom of the slide rail.