User's Guide

- 9 -
5.2 Industry Canada statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Caution Exposure:
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS102 and users can
obtain Canadian information on RF exposure and compliance.
Le dispositif répond à l'exemption des limites d'évaluation de routine dans la section 2.5 de RSS102
et les utilisateurs peuvent obtenir des renseignements canadiens sur l'exposition aux RF et le respect.
This equipment should be installed and operated with a minimum distance of 20 centimeters between the
radiator and your body.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 centimètres entre le radiateur et
votre corps.
The final end product must be labeled in a visible area with the following:
The Industry Canada certification label of a module shall be clearly visible at all times when installed in the
host device, otherwise the host device must be labelled to display the Industry Canada certification number of
the module, preceded by the words “Contains transmitter module”, or the word “Contains”, or similar wording
expressing the same meaning, as follows:
Contains transmitter module IC: 8879A-TIMOMWAN201
where 8879A-TIMOMWAN201 is the module’s certification number.
5.3 CE
Mira MWA-N2 and TimoTwo comply with the Essential Requirements of RED (Radio Equipment Directive) of
the European Union (2014/53/EU). Mira MWA-N2 and TimoTwo meet the ETSI EN 300 328 V2.1.1
conformance standards for radio performance.
5.4 Compliance Marking
5.4.1 FCC & Industry Canada
CRMX modules are FCC certified radio module that carries a “Modular” grant CRMX radio modules complies to
the “Intentional Radiator” portion (Part 15c) for FCC certification: Part 15.247 Transmitter tests.
An end product, incorporating a CRMX module, does not require additional testing or authorization for the
CRMX transmitter (or transceiver, in the case of RDM or Flex products). Host end products can use the FCC ID
of the certified module as the FCC ID of the host end product. A label displaying the CRMX module’s FCC ID
must be affixed and visible on the host end product for approval
FCC IDs are required for host end products with radio transmitters.