MSDS

Page:3/7
Version:
1.0
Date of issue/Date of revision:
06/11/2013
Date of previous issue:
00/00/0000
Small spill
:
Move containers from spill area. Vacuum or sweep up material and place in
a designated, labeled waste container. Dispose of via a licensed waste
disposal contractor.
Large spill
:
Vacuum or sweep up material and place in container for disposal. Never
place down drain.
7. Handling and storage
Handling
:
Avoid inhalation or contact with skin, eyes or clothing. Avoid container
breakage. Do not contaminate water sources when disposing of equipment
washwater or rinsate. Keep out of lakes, stream or ponds. Keep out of reach
of children.
Storage
:
Store in original container in a cool, dry, well-ventilated area inaccessible
to children and pets. Do not contaminate food or feedstuffs.
8. Exposure controls/personal protection
Occupational exposure limits
No exposure standard allocated.
Consult local authorities for acceptable exposure limits.
Recommended monitoring
procedures
:
If this product contains ingredients with exposure limits, personal,
workplace atmosphere or biological monitoring may be required to
determine the effectiveness of the ventilation or other control measures
and/or the necessity to use respiratory protective equipment.
Engineering measures
:
Use adequate ventilation to keep the airborne concentrations below the
recommended exposure standard.
Hygiene measures
:
Wash thoroughly with soap and water after handling. Remove and launder
contaminated clothing before reuse.
Personal protection
Respiratory
:
No special respiratory protection required. If ventilation is inadequate to
keep the airborne concentrations below the recommended exposure
standard wear appropriate respiration protection.
Hands
:
Eyes
:
Protective eyewear is not required, but may be used in situations were
contact is expected.
Skin
:
Wear long-sleeved shirt, long pants, shoes with socks. Remove and wash
contaminated clothing before reuse.
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked
to ensure they comply with the requirements of environmental protection
legislation. In some cases, fume scrubbers, filters or engineering
modifications to the process equipment will be necessary to reduce
emissions to acceptable levels.
9. Physical and chemical properties
Physical state
:
liquid
Flash point
:
Not Applicable
Burning time
:
Not Applicable
Auto-ignition temperature
:
Not Applicable
Flammable limits
:
Not Applicable