Installation Instructions

Eng
10
x2
1
x24
x4
50mm
45mm
45mm
x10
2
x2
3
x4
50mm
Installation
1. On one side of the frame, position two rods crosswise on
frame, with holes on rods aligned with those on frame and
on crossing, and secure with long screws and nuts (Figs 1
and 2, ve places).
2. Repeat previous step on other side of frame (Figs 1 and 2,
ve places).
3. Install both C-shaped mixer rods on axle using short screws
and nuts (Fig 3).
4. Position axle onto lower barrel half.
5. Secure upper barrel half onto lower barrel half and secure
with long screws and nuts (Fig 4, fourteen places).
6. Secure axle to barrels with provided accessories (two
screws and drum base) (Fig 5).
7. Insert axle on both sides into frame holes (Figs 6 and 2).
8. Install locking mechanism on both sides to frame with
provided screws and nuts (Fig 8).
9. Screw barrel lids on lower and upper barrel halves (Fig 9).