MSDS

M A TE R I AL S A F E T Y D A T A SH E E T
511 Seal & Enhance
Impregnating Color Enhancer
02-2009
Osha's Hazard Communication Standard US Dept. of Labor
Identity No: Name: 511 Seal & Enhance
Section 1
Manufacturers Name: Miracle Sealants Company
Address: 12318 Lower Azusa Road
Emergency Phone: [phone]
City: Arcadia
State: CA
P
hone: 626-443-6433
Date Prepared: 02-2009
Section 2 - Hazardous Ingredient/Identity Information
Hazardous Components CAS# OSHA PEL ACGIH TWA
Solvent Naphtha (Petroleum) 64742-88-7 500 ppm 100 ppm
Medium Aliphatic
Section 3 - Physical /Chemical Characteristics
Boiling Point: Appx. N200° C Specific gravity (H20=1) -1.25
Vapor pressure: Not Determined Melting point: Not Determined
Vapor density(air=1) : Heavier than air Evaporation rate(Butyl) : ó1
Solubility in water: None
Appearance and odor: Clear, Colorless to amber Liquid.
VOLATILE BY VOLUME: ö 60-70%
VOC CONTENT: 591 g/L
Section 4 - Fire and Explosion Hazard Data
Flash point: 145° F Method: Pensky-Martens
closed cup ASTM D 93
Flammable limits: Not tested
LEL: not tested UEL: Not tested
pH: Not Applicable DOT#: UN 1268
NFPA hazard rating- HFRS (0-Least, 4-Extreme): 2
HMIS hazard rating- HFR (0-Least, 4-Extreme): 2
Extinguish media: Foam, water spray or fog. Dry chemical powder, CO2, sand or
earth may be used for small fires only. Do not discharge extinguishing waters
into the aquatic environment.
Special fire fighting procedures: wear full protective clothing and self-contained
breathing apparatus.
Unusual fire and explosion hazards: none
Section 5 - Reactivity Data
Stability: Conditions to avoid: extreme heat and open flames
Hazardous Combustion products:
Burning can produce the following combustion products:
Oxides of carbon Oxides of nitrogen
Oxides of silicone Traces of Hydrogen Fluoride
Carbon monoxide is highly toxic if inhaled; carbon dioxide is sufficient concen-
trations can act as a asphyxiant. Acute overexposure to the products of combus-
tion may result in irritation of the respiratory tract.
Section 6 - Health Hazard Data
Harmful or fatal if swallowed
Causes eye and skin irritation
Harmful if swallowed
Harmful if inhaled
Harmful if absorbed through skin
Aspiration may cause lung damage
May cause allergic skin reaction
May cause dizziness and drowsiness
May cause liver and kidney disorders
Medical conditions generally aggravated by exposure- same as signs and
symptoms of over exposure.
Emergency and First Aid Procedures:
Eyes: Flush with water for 15 minutes. If irritation persists call a physician.
Skin: wash off with soap and clean water for 15 minutes. If irritation persists call
a physician.
Ingestion: Drink large amounts of water. Call Physician
Inhalation: Remove person to fresh air. If not breathing, administer artificial res-
piration including oxygen. Provide medical attention.
Section 7 - Precautions for safe handling and use
Steps to be taken in case material is released or spilled: soak up with inert
absorbent material.
Scoop up and place in a proper waste disposal container.
Waste disposal method: Dispose of in accordance with state and local
regulations.
Precautions to be taken in handling and storing: store in a cool, dry place, out of
direct sunlight.
Do not freeze less than or equal to 32° F or heat above 110° F.
Other precautions: KEEP OUT OF REACH OF CHILDREN. Follow directions on the
container for proper use of this product.
Section 8 - Control Measures
Respiratory protection: Ventilate by opening all doors and windows. If exposure
above the TLV or PEL require a NIOSH approved respirator equipped for the
exposure or suitable respiratory protection per 29 CFR 1910.134 is required.
Ventilation:
Local exhaust- if available Special- none
Mechanical- if available Other- None
Protective gloves: Plastic or rubber, chemical resistant
Eye Protection: Tight fitting, splash, proof safety goggles.
Other protective clothing or equipment: chemical resistant clothing.
Work hygienic practices: wash hands thoroughly before handling food stuffs,
liquids or tobacco products. Use common sense and care around chemicals.
Never mix this product with other chemicals. Consult your supervisor for all
other hygienic and safety practices. All practices depend on your specific busi-
ness. Directions for use normally found on label which will dictate engineering
and control measures.
Section 9 - Shipping
U.S. Department of Transportation Classification (49CFR)
ID # UN1993
Proper Shipping Name PETROLEUM DISTILLATES, N.O.S.
Class/ Division 3
P
acking group III
Marine Pollutant: No
Transportation Class: 55
IMDG
ID # UN1268
Proper Shipping Name: PETROLEUM DISTILLATES, N.O.S.
Class/ Division 3
Packing group III
IATA (Country variations may apply)
Section 10 - Regulatory Information:
Toxic Substances Control Act (TSCA): This product and/or all the ingredients
contained in this product have been registered under the Toxic Substances
Control Act.
SARA: No SARA 313 chemicals identified.
Section 302 - Extremely Hazardous Substances:
None.
Section 304 - CERCLA Hazardous Substances:
Cas # Appx. Wt. % Component name
1330-20-7 4.5 Xylene
100-41-4 1.3 Ethylbenzene
108-88-3 Trace Toluene
Section 312 - Hazard Class:
Acute: Yes Chronic: Yes Fire: Yes
Pressure: No Reactive: No
Section 313 - Toxic Chemicals:
Cas # Appx. Wt. % Component name
1330-20-7 4.5 Xylene
100-41-4 1.3 Ethylbenzene
Supplemental State Compliance Information
California:
Warning: This product contains the following chemical(s) listed by
the state of California under the Safe Drinking Water and Toxic Enforcement Act
of 1986 (Proposition 65) as being known to cause cancer, birth defects or other
reproductive harm.
Cas # Appx. Wt. % Component name
108-88-3 Trace Toluene
Massachusetts:
Cas # Appx. Wt. % Component name
1330-20-7 4.5 Xylene
100-41-4 1.3 Ethylbenzene
New Jersey:
Cas # Appx. Wt. % Component name
1330-20-7 4.5 Xylene
100-41-4 1.3 Ethylbenzene
68988-56-7 4-8 Trimethylated silica
3555-47-3 Trace Tetra(trimethoxysiloxy) silane
Pennsylvania:
Cas # Appx. Wt. % Component name
68988-56-7 4-8 Trimethylated silica
1330-20-7 4.5 Xylene
EPA Hazard Waste: Not Available
NOTE: Miracle Sealants believes the data set forth are accurate. Miracle
Sealants makes no warranty with respects thereto and disclaims all
liability or reliance thereon. Such data are offered solely for consideration,
investigation and verification. Also, the data set forth is for the concentrated
finished product. All lab samples are for experimental purposes only and
used at the customers discretion.
www.miraclesealants.com