Installation Instructions

SET

电源开关

Power switch

拾音头 pick

up head

电池仓

Battery bin

1、长按电源开关开机，开机后显示屏上显示当前状态，长按 SET 键直到显示屏显示 SEL 马

上松开手，再短按 SET 可以切换频点，频率步进为 500K，具体的见频率表。

Press the power switch to turn on, display the current state on the display screen after boot,

press the SET key until the display SEL immediately release the hand, then press the SET to switch

frequency points, frequency step 500 K, see the frequency meter for details

2、按键功能图示如下：

The key function icon is as follows:

2、按管体电池仓丝印正确装入两节 1. 5V- 5

号电池

Correctly install two 1.5 V-5 batteries according to tube battery bin screen

3、开关机 Startup & Shutdown：长按 2 秒开机，长按 2 秒关机

Long press 2 seconds to boot, long press 2 seconds to shut down

4、开机后，显示屏显示麦克风的当前通道，电池电量，话筒静止 10 秒后自动进入静音模式

After boot, the display displays the current channel of the microphone, battery power, and the microphone

automatically enters mute mode after 10 seconds of rest

5 、音量大小调整 Volume adjustment：单按 SET 键可以调整音量大小

Click SET to adjust the volume

6、同时按下电源按键+ SET 进行麦克风 ID 识别,完成操作后就不会再被其它麦克风串频干扰了

Press the power button at the same time SET ID microphone identification, after the operation will

not be disturbed by other microphone serial frequency

PAGE 1
、长按电源开关开机，开机后显示屏上显示当前状态，长按 SET 键直到显示屏显示 SEL 马上松开手，再短按 SET 可以切换频点，频率步进为 500K，具体的见频率表。 Press the power switch to turn on, display the current state on the display screen after boot, press the SET key until the display SEL immediately release the hand, then press the SET to switch frequency points, frequency step 500 K, see the frequency meter for details 2、按键功能图示如下：电源开关 The key function icon is as follows: Power switch SET 拾音头 pick up head 2、按管体电池仓丝印正确装入两节 1.
PAGE 2
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.