Service manual

SECTION 8
PA-46-350P, MALIBU HAND/SERV/MAINT
SECTION 8
PA-46-350P, MALIBU HAND/SERV/MAINT
ISSUED: FEBRUARY 23, 1999 REPORT: VB-1710
8-11
ISSUED: FEBRUARY 23, 1999 REPORT: VB-1710
8-11
8.21 OIL REQUIREMENTS
The oil capacity of the Textron Lycoming TI0-540-AE2A engine is 12
quarts with an inflight minimum quantity of approximately 2.75 quarts.
Maximum endurance flights should begin with 12 quarts of oil. For all
shorter flights, it is recommended that oil be added if the quantity falls to 10
quarts. It is recommended that engine oil be drained and renewed every 50
hours, or sooner under unfavorable conditions. Full flow cartridge type oil
filters should be replaced each 50 hours of operation. The following grades
are required for temperatures:
When operating temperatures overlap indicated ranges, use the lighter
grade oil.
NOTE
Refer to the latest issued of Lycoming Service
Instruction 1014 (Lubricating Oil
Recommendations) for further information.
MIL-L-22851
Average Ambient MIL-L-6082B Ashless Dispersant
Temperature SAE Grade SAE Grades
All Temperatures
Above 80°F
Above 60°F
30°F to 90°F
0°F to 70°F
Below 10°F
15W-50 or 20W-50
60
40 or 50
40
30, 40 or 20W-40
30 or 20W-30
MINERAL
OIL NOT
APPROVED
8.21 OIL REQUIREMENTS
The oil capacity of the Textron Lycoming TI0-540-AE2A engine is 12
quarts with an inflight minimum quantity of approximately 2.75 quarts.
Maximum endurance flights should begin with 12 quarts of oil. For all
shorter flights, it is recommended that oil be added if the quantity falls to 10
quarts. It is recommended that engine oil be drained and renewed every 50
hours, or sooner under unfavorable conditions. Full flow cartridge type oil
filters should be replaced each 50 hours of operation. The following grades
are required for temperatures:
When operating temperatures overlap indicated ranges, use the lighter
grade oil.
NOTE
Refer to the latest issued of Lycoming Service
Instruction 1014 (Lubricating Oil
Recommendations) for further information.
MIL-L-22851
Average Ambient MIL-L-6082B Ashless Dispersant
Temperature SAE Grade SAE Grades
All Temperatures
Above 80°F
Above 60°F
30°F to 90°F
0°F to 70°F
Below 10°F
15W-50 or 20W-50
60
40 or 50
40
30, 40 or 20W-40
30 or 20W-30
MINERAL
OIL NOT
APPROVED
FOR REFERENCE ONLY
NOT FOR FLIGHT