Specifications

18
19
Installing the Mirage – SecuringInstalling the Mirage – Setup and Tuning
Securing the Mirage
Apply light pressure to the left hand side of the mirror and
insert the screws into the fixing points. Securely tighten
the screws by hand.
To ease hole alignment it may be necessary to
remove the black caps from the fixing points and
loosen the screws. This will allow movement of the
catch plate to enable alignment of all screws holes.
Retighten the screws. Insert the screw caps into the
heads of the screws and push them firmly into place.
Remove the protective cover from the Mirage glass.
Cleaning Instructions
To clean the mirror and frames, use only a soft
damp cloth. Under no circumstances are abrasive
cleaners to be used, failure to observe this warning will
invalidate the guarantee.
a
nd
n
v
e
n
ing will
Screw and
screw cap
Wall
frame
Mirror
frame
Mirror cut away
to show mirror
frame and
fixing point
The Touch Controls
The touch controls on the mirror have the following functions:
Power On/Off – Turns the Mirage on from, or off to, standby.
VOL (Volume Down/Up) – Adjust the volume.
Input Source – Displays the Input Source menu and allows source selection: DTV,
ATV, SCART, COMPONENT, PC-RGB, HDMI, COMPOSITE, S-Video.
Each touch steps the menu to the next input. The highlighted input will be selected and
the menu cleared when the control is not touched for a couple of seconds.
PR (Programme Down/Up) – Selects previous or next programme.
LED Lights On/Off – turns the built-in LED lights no and off – not available on the
remote controls.
The touch controls do not work if more than one symbol is touched at once.
NEW INSTALLATION
Language English
Auto Tuning
Please select country first,
Then select Start to update info.
Country selection UK
Start Cancel
EXIT MENU OK
OK
EPG MENU
EXIT
OK
EPG MENU
EXIT
EPG MENU
16:9
AUDIO
3 Select the required country with the LR buttons. Choose from:
Australia, Austria, Belgium, Bulgaria, Croatia, Czech, Denmark,
Finland, France, Germany, Greece, Hungary, Italy, Luxembourg,
Netherlands, Norway, Poland, Portugal, Romania, Russia, Serbia,
Slovenia, Spain, Sweden, Switzerland, UK.
4 Press the D button to select Start.
5 Press the OK ( ) button to start the auto tuning.
The Channel Tuning dialogue will be
displayed to show the progress of
the tuning.
When tuning is complete the
Channel Tuning dialogue will be
cleared and the first available
channel will be selected.
If additional sources are being used with the Mirage their operation
should now be checked (see input selection on page 23).
If a CAM is installed make sure it is activated and fully functional as
per its service provider’s instructions.
Once the Mirage is tuned and external inputs are working correctly,
press the POWER (
) button on the remote control to put the
Mirage into standby.
Channel Tuning
TV
ATV : 0 Programme(s)
DTV : 0 Programme(s)
Radio : 0 Programme(s)
Press <Menu> to skip.
Press <Exit> to exit.
EXIT
MENU
Please note – Do not use the touch controls until the power has been on for 30 seconds – the
controls need time to adjust their sensitivity to match their environment.