User manual

Extended Settings and Functions
39
 Switch the channel directly on your mobile device.

During smartSTREAM mode (BOX2IP mode) you can switch off your TV set.
9 Extended Settings and Functions
9.1 Installation
The default settings apply to a standard satellite system. Any further system functions (e.g.
unicable system or motor antenna) should be manually set in the menu Installation:
CAUTION!
 In case of doubt, have those settings being made by an expert. Usu-
ally, there are no required settings within scope of normal use of the
system.
9.1.1 Antenna Connection
1. In the menu Installation, select the submenu Antenna Connection and confirm by
pressing OK.
2. Select by using the keys and if a
Fixed Antenna or a Motor Antenna is
connected to the receiver.
3. Press EXIT to leave the submenu Antenna Connection.
4. Press EXIT again to leave the menu Installation and to return to TV operation, or go to
another submenu

If you selected a Motor Antenna , then such antenna should be further
configured at the menu item Antenna Setup.
9.1.2 Satellite List
The submenu Satellite List states a preset list of possible satellites. Depending on your
antenna system you can select the satellites used for receiving channels:
1. In the menu Installation, select the submenu Satellite List and confirm by pressing OK
2. Select the satellite you want to receive by pressing the keys PR+ and PR-, and confirm
by pressing OK.
The selected satellite will be correspondingly marked ( ).

You may also edit the satellite list by selecting
one of the buttons on the right edge of the
menu window.
To change an entry:
1. Press the red function key (SHIFT).